The 5.56mm Armalite AR-15 rifle was a radical design when it was adopted by the US Army as the M16 from 1965, but it required advanced materials and relatively complex tooling to produce. Armalite therefore developed the AR-18 as a simpler weapon, made mostly from steel stampings. It was a low-cost design intended for production in less-developed countries that wanted to adopt the 5.56mm cartridge, but had a more limited industrial base.
The AR-18 was a selective-fire 5.56mm rifle like the M16, but it used a conventional gas piston rather than M16-style direct gas impingement, in which propellant gas acts directly on the bolt carrier. Whereas the M16’s buffer mechanism protrudes into the butt and prevents use of a folding stock, the AR-18’s mechanism was fully contained in the receiver, allowing a side-folding stock to be fitted as standard.
The AR-18 was tested by the US Army in 1964 and the British Army in 1966. These trials found that its functioning was rather dependent on ammunition quality; and that although the basic design was sound, its reliability would need to be improved before it was acceptable as a service rifle. In particular, the British felt it performed poorly in the mud and sand tests.
Armalite produced only a few AR-18s itself, but licensed production to a Japanese company during 1970–74, and then to the Sterling Armaments Company in Britain during 1975–83. The Sterling factory was practically on RSAF Enfield’s doorstep, and RSAF engineers visited several times to view the AR-18 production line. Although never adopted by any army, a number of AR-18s found their way into the hands of Provisional Irish Republican Army terrorists during ‘the Troubles’ in Northern Ireland.
THE IMPROVED ‘O’-SERIES PROTOTYPES (1975–76)
RSAF Enfield now began to develop and improve the initial prototype weapons, intending to have refined weapons ready by the NATO ammunition trials, scheduled for 1977. The first phase involved construction of another 12 prototypes, known as the ‘O’ series since their serial numbers began with weapon 01. Although these were similar to the previous ‘Double O’ series, detailed differences included a redesigned trigger and pistol grip, and repositioning of the sling-attachment points to the top of the weapon to allow it to be carried in what the designers termed a ‘handbag style’. The flash eliminator was modified to allow the weapon to fire NATO-standard 22mm rifle grenades, and the magazine release was moved from the right side of the body to the left – something that would cause problems later. Meanwhile, the selector switch was replaced by a rotary type with only two positions: single shot and automatic; the three-round-burst function of the ‘Double O’-series weapons disappeared.
Of the 12 ‘O’ prototypes, six were standard IWs, five of which were configured for right-handed use and one for left-handed use. Two extra IWs were built, one with flip-up emergency sights in case the SUSAT optical sight unit failed or was damaged, and the other with a stabilizing monopod beneath the barrel. Four LSW prototypes were constructed, two of which were right-handed models and one left-handed, all firing from closed bolt on single-shot and open bolt on automatic. The last of the four LSWs (also the twelfth and final ‘O’ prototype) was fitted with a quick-change barrel for improved sustained-fire performance, and a muzzle brake to reduce recoil rather than the standard flash eliminator. These modifications were rejected, however, since they increased both cost and weight while decreasing commonality with the IW – and commonality was a major selling point of the system. The improvement in sustained-fire capability was also relatively small, since the weapon remained magazine (rather than belt) fed.
The Enfield Weapon System was unveiled to the press in June 1976, ahead of the NATO ammunition trials scheduled for the following year. The publicity material implicitly assumed that it would become the British Army’s next infantry weapon system in due course, even though no formal acceptance – nor any trials – had taken place, and only a small number of essentially hand-built prototypes had actually been produced. The publicity material highlighted the innovative design of the Enfield weapons. It also emphasized the reduction in length and weight compared to the SLR and GPMG they would replace, while stating that although the detailed performance was ‘classified’, they were ‘at least as effective as the current 7.62mm weapons over normal ranges and conditions’ (quoted in Raw 2003: 37). Even the two photographs included in the press pack were carefully crafted to add to the image of modernity. In each case, the soldier holding the new weapon wore the latest equipment, including the new ballistic helmet, while his counterpart with SLR or GPMG was dressed in dated equipment and old-fashioned steel helmet.
THE XL64 AND XL65 SERIES (1976–77)
The weapons finally received formal service designations for the second phase of the feasibility study, which would finalize the design for the NATO ammunition trials. British weapon designations started with ‘L’ for ‘Land Service’, while experimental items were designated as ‘XL’ until they entered service. The standard right-handed version of the IW was thus designated as the XL64E5, while its left-handed equivalent was the XL68E2. Meanwhile, the LSWs became the XL65E4 (right-handed) and XL69E1 (left-handed). More prototypes would be needed for the NATO trials. In all, 36 IWs (33 right-handed and three left-handed, all firing from closed bolts) and 36 LSWs (32 right-handed and four left-handed, all still firing from a closed bolt on single-shot and open bolt on automatic) were produced.
These prototypes included several modifications compared to the previous ‘O’-series weapons. A hinged ejection-port cover was fitted, to prevent sand and grit entering the mechanism. The previous ‘push-through’ safety catch was replaced by a lever-type catch as used on the M16. The magazine release was moved once more, this time to a position behind the magazine where it could easily be accessed by both right- and left-handed users, but was unlikely to be activated accidentally. The ‘handbag’-style sling was replaced with a more conventional one, and a slightly curved 30-round magazine appeared for the LSW, supplementing the straight 20-round version which remained standard for the IW. Only limited testing could be conducted before the NATO trials, but it was hoped and expected that the Enfield Weapon System would do well in the latter, and would be adopted by the British Army with little further modification. As we shall see, this was not to be the case.